United States · design temperature
Heat pump sizing in Albuquerque, NM
−6 °C(21 °F) design temperature
Design temperature used for Albuquerque, NM: -6 °C (21 °F) — the 99 % annual heating design temperature, from 10 years of reanalysis weather. Treat it as ±1 °C: your street can be colder or milder than the grid cell.
What that means for load
Design heat load = your home's heat-loss coefficient (UA) × (70 °F − 21 °F). Illustrative only — your own UA is what matters, and a contractor's quote is often sized from a rule of thumb instead:
| UA (BTU/h·°F) | Design load (BTU/h) | ≈ tons |
|---|---|---|
| 200 | 9,864 | 0.8 |
| 300 | 14,796 | 1.2 |
| 400 | 19,728 | 1.6 |
| 500 | 24,660 | 2.1 |
Measure yours
Temsor RightSize reads 12–24 months of your utility bills, fits your real UA with an uncertainty range, and checks the heat pump you were quoted against real cold-climate capacity data. Try the free calculator.
Nearby cities
- El Paso, TX (-1 °C design)
- Colorado Springs, CO (-15 °C design)
- Phoenix, AZ (4 °C design)
- Tucson, AZ (2 °C design)
Engineering estimate, not a stamped Manual J / permit document. Method validated on simulated homes. See the disclaimer.